High Feed

  • Marka:WIDIN
  • Kod:PF503
  • Açıklama:3 X D / POWER MAX DRILL - STUB / HIGH SPEED MACHINING - Suitable for high speed cutting with newly developed raw-material and new coating.
  • Detaylı Bilgi

High Feed

  • Marka:WIDIN
  • Kod:PF505
  • Açıklama:5 X D / POWER MAX DRILL - MEDIUM / HIGH SPEED MACHINING - Suitable for high speed cutting with newly developed raw-material and new coating.
  • Detaylı Bilgi

High Precision

  • Marka:WIDIN
  • Kod:HP503
  • Açıklama:POWER MAX DRILL-HIGH PRECISION - Applyed highly precise hole tolerance on the tool . - Increased tool life by minimizing chatter and resonance on the (through hole) penetrated hole or (blind hole) one-side open hole area.
  • Detaylı Bilgi

Karbür Matkap (Kısa)

  • Marka:WIDIN
  • Kod:P503A(F)
  • Açıklama:POWER MAX DRILL - STUB / DIN 6537K ■Shank Form · P503A : DIN 6535 HA - straight A type · P503F : DIN 6535 HE - 2。 Whistle Flat F type
  • Detaylı Bilgi

Karbür Matkap (Kısa)

Karbür Matkap (Orta)

  • Marka:WIDIN
  • Kod:PDM
  • Açıklama:5 x D / POWER DRILL - MEDIUM
  • Detaylı Bilgi

Karbür Matkap (Spiral)

Karbür Matkap (Spiral - Uzun)

Giga Jet Drill for steels

  • Marka:TUNGALOY
  • Kod:DSX
  • Uygulama:For High Speed and efficient Deep Hole Drilling of Steels Coated solid carbide drills with spiral oil holes
  • Açıklama:• The cutting parameters shown in the table are merely a starting guideline for general machining. • Values should be varied depending on the power or rigidity of the machine to be used. • For the smaller side of drill diameters, select lower feeds. • Chip packing in the oil holes may cause drill breakage. • A filter preventing the circulation of chips should be used on coolant supply. • Inconel is trademark of Huntington Alloys, Inc. Cat. No. Stock • Standard cutting conditions Dimensions (mm) • No. of revolutions (min-1) = Cutting speed  1000  3.14  Tool diameter
  • Detaylı Bilgi

Giga Mini Drills

  • Marka:TUNGALOY
  • Kod:DSM
  • Uygulama:External Coolant Supply
  • Açıklama:• When the drilling depth is deeper than L/D = 5, use drill pecking every 10 to 50% of the drill diameter. • The above cutting conditions are applied to when a water soluble cutting fluid is used. • For drilling a hole smaller than ø0.3 mm, use of a starting drill is recommended. • When setting the drill, the drill run out should be within 0.002 mm on the taper (Especially for the drill diameter smaller than ø0.5 mm)
  • Detaylı Bilgi
Pill Digital