Açıklama:3 X D / POWER MAX DRILL
-HIGH PRECISION
- Applyed highly precise hole tolerance on the tool.
- Increased tool life by minimizing chatter and
resonance on the (through hole) penetrated hole
or (blind hole) one-side open hole area.
Açıklama:3 X D / POWER MAX DRILL
-HIGH PRECISION
- Applyed highly precise hole tolerance on the tool.
- Increased tool life by minimizing chatter and
resonance on the (through hole) penetrated hole
or (blind hole) one-side open hole area.
Açıklama:8 X D / POWER MAX DRILL
-HIGH PRECISION
- Applyed highly precise hole tolerance on the tool.
- Increased tool life by minimizing chatter and
resonance on the (through hole) penetrated hole
or (blind hole) one-side open hole area.
Açıklama:POWER MAX DRILL - STUB INTERNAL
COOLANT/ DIN 6537K
■ Shank Form
· PI503A : DIN 6535 HA - straight A type
· PI503F : DIN 6535 HE - 2。 Whistle Flat F type
Açıklama:POWER MAX DRILL - MEDIUM INTERNAL
COOLANT/ DIN 6537L
■ Shank Form
· PI505A : DIN 6535 HA - straight A type
· PI505F : DIN 6535 HE - 2。 Whistle Flat F type
Açıklama:POWER MAX DRILL-HIGH PRECISION
- Applyed highly precise hole tolerance on the tool .
- Increased tool life by minimizing chatter and
resonance on the (through hole) penetrated hole
or (blind hole) one-side open hole area.
Uygulama:For High Speed and efficient Deep Hole Drilling of Steels Coated solid carbide drills with spiral oil holes
Açıklama:• The cutting parameters shown in the table are merely a starting
guideline for general machining.
• Values should be varied depending on the power or rigidity of the machine to be used.
• For the smaller side of drill diameters, select lower feeds.
• Chip packing in the oil holes may cause drill breakage.
• A filter preventing the circulation of chips should be used on coolant supply.
• Inconel is trademark of Huntington Alloys, Inc. Cat. No. Stock
• Standard cutting conditions Dimensions (mm)
• No. of revolutions (min-1) = Cutting speed 1000 3.14 Tool diameter
Açıklama:• When the drilling depth is deeper than L/D = 5, use drill pecking every 10 to 50% of the drill diameter.
• The above cutting conditions are applied to when a water soluble cutting fluid is used.
• For drilling a hole smaller than ø0.3 mm, use of a starting drill is recommended.
• When setting the drill, the drill run out should be within 0.002 mm on the taper (Especially for the drill diameter smaller than ø0.5 mm)